Bottling Tank Fill Controller

Bottling Tank Fill ControllerThis controller will allow a bottling tank to stay full from your storage vessel. It will maintain a level between approx. 3" to 6 3 8" from top. By doing this you can concentrate on bottling not how full your bottler is. When finished simply store it or if you are not completely finished just flip the switch off. (If some time has past, clean floats before you use it again.) To do this it uses your honey pump and controls the power to the pump. Just

This controller will allow a bottling tank to stay full from your storage vessel. It will maintain a level between approx. 3" to 6-3/8" from top. By doing this you can concentrate on bottling not how full your bottler is. When finished simply store it or if you are not completely finished just flip the switch off. (If some time has past, clean floats before you use it again.)

To do this it uses your honey pump and controls the power to the pump. Just put a hose from your storage vessel to your bottler tank with the pump inline. Then plug the pump into the controller.

The controller hangs on the outside of the bottler and the floats read the level of the honey. Then the controller turns the pump on or off as needed to keep the tank full. 

As a piece of mind, a #45 bucket alarm can be used in conjunction and will alarm if tank get too full. If the happens for some reason, (if the floats have not been cleaned from dried honey) then just flip the switch off.

When finished using, unplug and loop the cord through the carabiner and hang from a shelf or hook.