
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 9 - Jul 14
For Your Every Summer RSVP, with Code: SUMMER15
Description
Merchant Automotive 10381 Transfer Case Upgrade with Drain PlugsThe Merchant Automotive 10381 Transfer Case Upgrade with Drain Plugs for your 01 07 GM 6. 6L Duramax is the best upgrade you can make to your GM transfer case (model 136, 146, 246, 261, 261HD, 263HD, 263XHD, 261XHD) to prevent the ever increasing problem of pump rub. What is pump rub? The GM transfer cases use a gear pump inside the case that is driven off the mainshaft. The pump forces oil to the planetary as well as the drive sprocket sleeve.
The Merchant Automotive 10381 Transfer Case Upgrade with Drain Plugs for your 01-07 GM 6.6L Duramax is the best upgrade you can make to your GM transfer case (model 136, 146, 246, 261, 261HD, 263HD, 263XHD, 261XHD) to prevent the ever increasing problem of pump rub.What is pump rub?
The GM transfer cases use a gear pump inside the case that is driven off the mainshaft. The pump forces oil to the planetary as well as the drive sprocket sleeve. Because the pump is driven by the shaft, the housing of the pump must 'float' in the rear housing. There are 5 tabs around the housing that fit into spots in the rear housing to position the pump. Over time, the pump can start to wear on the rear housing. GM installed a spring steel clip in the housing intended to prevent wear but the clip can break and render useless
Being that the pump housing is aluminum and is a harder material then the magnesium rear housing, it can wear a hole in the rear housing and cause a very small leak. This leak is high enough in the case that it typically will not leak when vehicle is not moving and therefore not leaving any drops on the ground. Typically the condition is not found until there is transfer case damage from running the case out of fluid.With installation of this kit, you will have a LIMITED LIFETIME WARRANTY against pump rub.
Included Components:
- Merchant Automotive billet transfer case pump housing
- Transfer case adapter gasket at trans
- RTV Silicone
- Blue Threadlock
- Magnetic Drain Plugs
- Merchant Automotive sticker
|
Application Guide |
||
|
Year |
Model |
Transfer Case Model Number |
|
1998-2007 |
GM Silverado/Sierra - 1500, 1500HD, 2500, 2500HD, 3500 |
NP246, NP261HD, NP263HD, NP261XHD, NP263XHD |
|
1998-2003 |
Blazer / Jimmy |
NP236 |
|
1999-2005 |
Astro/Safari |
NP136 |
|
1999-2007 |
Escalade |
NP246, NP149 |
|
2002-2007 |
Avalanche 1500/2500 |
NP246, NP261, NP263, NP263HD |
|
1998-2007 |
Suburban/Yukon/Tahoe/Yukon XL 1500/2500 |
NP246 |
Frequently Asked Questions:
What do I do with the OEM anti rattle clip when installing this upgrade?
You can discard the factory clip during installation of this kit. Its been designed to work with the clip removed.
What other parts will I need to install this upgrade kit?
We tried to make the kit all inclusive for a basic installation. This is taking into consideration of course that its being installed as preventative measures. If its being installed as part of a repair or after pump rub has occurred, there is no real way to know the extent of the damage inside the case until it is torn down. Most times, as long as the case has not run out of fluid, it can usually be repaired with a new rear housing and seal and prevented from ever happening again using the upgrade kit. Regardless of the reason for installing this upgrade, you will need to refill the transfer case with oil. We recommend our Performance Transfer Case Oil for use in ALL transfer cases.
WARRANTY INFO:
Lifetime
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.8 ★★★★★
Based on 1038 reviews
Sort
Product Reviews
★★★★★ 5
This will work but prep is key!
I have an older RV that the gelcoat has dulled and is oxidized, but otherwise in good shape. I have buffed and polished in the past only for it to last a short time. I was looking up different products to try and this one has such good reviews, I thought I would give it a try. I bought the kit with the Poliglow and the Poliprep, with the scrubber and the microfiber glove. I started with the poliprep and it did a great job of gettting the streaks and black marks off. You spend a lot of time scrubbing to your likeness because anything that is still on the gelcoat when you apply the poliglow, it will be locked in there. The Poliglow is like a clearcoat that goes over the gelcoat. You have to build up layers and here are some of the tips and tricks I figured out that really helped my finished RV look great. First, make sure the applicator stays damp, this keeps the poliglow more uniform across the glove. Also, stick it in a zip lock bag when not using, you do not want it to dry out while you are using it. I found out that applying this in direct sunlight in warm temps, is the best method. This allows the poliglow to dry really fast. The first 3 or 4 layers will look streaky and dull but this is ok and as you build up the layers, the shine will come back. I found if you do this when its cooler, the layers do not dry as quick and you will get some permanent streaking or running. I had to remove a section I did in the evening because I noticed this. When in direct sunlight, this gave me the best results with no streaking or running. It dries fast and you can keep working. Like it says, do not do big sections at a time, keep it to small what you can reach sections and build those up and move on. As far as how much to buy? I have a 40 ft toy hauler and I got to kits and I had just enough to finish the whole thing minus the nose cap. I have Durabak on the nose cap, so I dont need to worry about that. I ended up buying one more bottle of the poliglow to have for my maintenance coats. Overall, I am pleased with how my 10 year old RV looks and other than some of the decals show age, it looks new again. If I were to buy a new RV, I would put this on right away and preserve the whole RV including the decals. Its not too expensive and its a lot of work, especially the prep, but it does end up with great results.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 21, 2023
★★★★★ 5
Excellent shine
Excellent line of products. Looking at the picture, you can see what the camper looked like before the Poli Glow. To the left of the window is the after Poli Glow.
It takes some elbow grease (follow instructions well) but well worth it.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 26, 2026
★★★★★ 5
Camping enthusiast approved
One bottle covered my 20ft camping trailer 4 coats and with a little remaining for future touch ups. It definitely increases the gloss. I'm glad I didn't waste my time with wax. This is like an easy wipe on clear coat. I will report back in the future for longevity.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 24, 2026
★★★★★ 4
buy more than you think your going to need to get a great shine and look!!
great product and leaves a great shine. The Poli Glow doesn't go as far as the video states and it depends on condition of RV, boat...This is a great product but takes more to get a great shine!!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 16, 2026
★★★★★ 5
poli glow shine
its works great .when applying more coats the shinier it gets
i used on several old boats because
the florida sun bakes the jell coat right off and no wax made can withstand salty seas , so why not ,, when you apply use the mit and don't gob it on .. nice and easy and recoat in five minutes when you get to about five coats you will be amazed.looks like new .. just a tip also after about a year or so and you want to re apply,, go to your local hardware store and get a gallon of high strength or non diluted floor stripper and put in spray bottle and use to remove old poli-glow also great for cleaning stubborn stains [ i use full strength ] just spray on and brush with a scrub brush and rinse ..and let dry and re apply ,, its also works on car faded bumpers ,, also never use harsh cleaners it will cause streaking the best thing i have found for cleaning the boat after poli glow was put on is car wash from auto store with wax or not it seems not to hurt the shine . it reminds me of mop an glow,,.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 29, 2020